![]() For more info check the size tables below. Original equipment and alternative options. My 86 studs are stamped with an M and use a metric lug, but when I swapped to a different rear the studs were stamped S and I had to get 7/16' lugs for it. If you are still unsure of your truck, car, or SUV's bolt pattern after reviewing the information below, please don't hesitate to call us at 32 or email us at. The 1965 Chevrolet El Camino bolt pattern is 5x120.65. Wheel size, PCD, offset, and other specifications such as bolt pattern, thread size (THD), center bore (CB), trim levels for 1981 Chevrolet El Camino. Check your wheel studs, and see if the top is stamped with an M for metric, or an S for standard. Take advantage of these great prices on high-quality wheels, and if you have any questions, don't hesitate to give us a call. ![]() Original equipment and alternative options. /rebates/8256&.com252ffind252f1985-chevrolet-el-camino-wheel-lug-nut. The 1965 Chevrolet El Camino tire sizes are 7.00/D14, 175/R14, 195/75R14, 195/70R15, 215/75R15. Wheel size, PCD, offset, and other specifications such as bolt pattern, thread size (THD), center bore (CB), trim levels for 1983 Chevrolet El Camino. Trending Questions How much should you pay to replace the compressor on a 2003 Lincoln navigator? How can you tell if spider gear is bad on 2003 Chevy suburban 1500? Why the resistant in ohmic devices is constant and in non ohmic not constant? Where is the heater relay in a 96 Aspire? What is an axle? How much does the Kobe v show weigh? Can you get a sump off an ef without removing the engine? What does it mean when you have antifreeze coming out of exhaust and cat converter on 95 dodge ram 1500 5.9 liter? What was Edsel Ford's wife's name? What kind of transmission can do burnouts to fit a 92 caprice wagon305 V8? How much oil is required for a 1992 Geo Prizm? Where is OBD2 port located on 2003 Chevrolet Silverado 12 ton 2door 4. Check the tables below to get all tire sizes, wheel sizes, bolt patterns (PCD), rims offset, and tire pressure. Try to match the offset, center-bore, and lug nut sizes when possible (again, fitment and safety issues).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |